At the end of the opening day of the 1:10 EP Touring Car Euros it is German ace Marc Rheinard and his Tamiya that top the time sheets here in Vila Real. Rheinard knocked a second off his opening timed run to remain fastest of the 145 runners while team-mate Viktor Wilck who was the next fastest in P4 jumps up into second. The German ran a new car for the final run of the day which he said felt different to the chassis he used in the earlier runs. The second car had more traction but was pushing more and so he remains undecided as to which chassis he will nominate for the start of qualifying.

Check out the full coverage on our event site here.

Read the original here:
Rheinard tops Opening Day at Euros

Tamiya driver Marc Rheinard has topped the time sheets for the first of the timed practice runs here at the 2008 Euros in Vila Real, Spain. Posting a time of 17 laps in 05:10.830 the German was 2/10th faster than fellow countryman and defending champion Ronald Volker over the 5 minute run. The 2008 European 1:12 Champion, Rheinard said his TRF416 was pretty good but he will run a fresh car in the last run of the day.

Check out the full coverage on our event site here.

See original here:
Rheinard tops first timed practice

A quick look through the pits here in Vila Real have revealed a number of new products being run and tested by some of the top drivers. Corally racer Marc Fisher from Germany is running some new prototype parts on his RDX Phi. There are new rear uprights that have 1mm lower top mounting points, also the front steering blocks have received some attention together with the new servo saver part that has simpler to adjust Ackermann.

Check out the full coverage on our event site here.

The rest is here:
Euros 1:10 - New in the pits

New from Losi for use with their 8ight range of chassis’ are two new spares boxes. The first box contains a complete ball bearing set for all 8ight-based race and RTR models and comes in a reusable box. This boxed set includes all of the necessary bearings you need, and is a cost-effective alternative to purchasing individual bearings. Losi have also released a clutch rebuild and service set, which includes all the service and tuning parts necessary for rebuilding the 8ight and 8ight-T clutch in one box.

Click more to see the clutch rebuild box… (more…)

View post:
Losi Bearing & Clutch service boxes